Installing With A 24-48 Vdc Power Supply (Option 3) - iDirect Evolution X7 Installation, Support, And Maintenance Manual

3. Connect the TX and RX coax cables to the X7 Router and secure but do not over-tighten.
See D.1, Coax Cable Preparation on page 33
4. Connect the AC power cord to the power source. This will power ON the X7 Router.
5. Monitor the front and rear panel lights during power on startup. See
X7 Router Front LEDs on page
6. Prepare PC for X7 Router connection as specified in
Connection to the X7 Router on page
7. Login PC to Web iSite as specified in
page 18.
8. Install the firmware and configure the satellite router as specified in
Configuring the X7 Router on page
4.5.2
For an X7 Router using a 36-76 VDC power supply (Option 3):
1. First, perform steps 1-6 of the Installation Checklist,
2. Set the X7 Router power switch to the OFF position (0).
3. Prepare the power cables per the instructions in
on page 41
4. Select the appropriate BUC voltage (+24 or +48 V), by sliding the BUC voltage selector
switch (Table 3-3, X7 Router Rear Panel Connector and LED Descriptions on page
Callout #8). 24 V BUC voltage selection is the factory setting.
5. Set the X7 Router power switch to the ON position (1).
6. Upon powering up, a Level 0 Reset occurs. Reset options are available in
Reset on page 45.
Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
CAUTION: Do not connect or disconnect the Tx or Rx IFL cable while the
satellite router is powered on; this action may result in damage to the BUC,
LNB, and/or X7 Router.

Installing With a 24-48 VDC Power Supply (Option 3)

CAUTION: If negative voltages are used such as Telecom -48VDC, the negative
most voltage is always connected to –ve terminal (in the Telecom case this
would be -48V) and the positive most voltage is always connected to the +ve
terminal (in the Telecom case this would be 0VR). Chassis can be referenced
to +ve, -ve or left floating (i.e. not connected to either +ve or –ve) as
required as the power module is fully isolated input to chassis.
and connect the power cables.
CAUTION: The BUC power requirement must match the proper voltage. The
BUC may sustain damage if used with the incorrect power supply.
for preparation details.
8.
Section 4.6, Preparing the PC for
18.
Section 4.7, Web Interface LED Status Indicators on
18.
Appendix E, DC Power Supply Installation
X7 Router Mounting
Section 3.1,
Section 4.8,
Section 4.1, on page 13.
Appendix F, X7
11:
17