Figure D-4. Attaching The Compression Fitting F-Type Connector; Figure D-5. Compression Fitting F-Type Weatherproof Plug And Tool - iDirect Evolution X7 Installation, Support, And Maintenance Manual

Coax Cable Preparation
8. Install the RG-6 connector compression sleeve, or mandrel, (top left (A) in
over foil and underneath the braid. A good, weatherproof outdoor connector mandrel
should have a visible O-Ring (bottom right (B)
NOTE: The white colored inner dielectric insulation should be flush with the inner
rear surface of the connector. Refer to the picture on the right (C) in
for an RG-6/RG-11 termination.
NOTE: Since the RG-11 connector has a built-in center pin, ensure that the coax
center pin makes contact to the internal seizing pin of the connector. Refer to
Figure
9. Finish connecting the cable to the connector with the compression tool connector, such as
Holland Compression Tool 1855 as shown in
36
D-4.

Figure D-4. Attaching the Compression fitting F-type Connector

Figure D-5. Compression fitting F-Type Weatherproof Plug and Tool

Figure D-4).
Figure D-5.
Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
Figure D-4)
Figure D-4