Table D-3. Rj-45 To Db-9 Pinouts - iDirect Evolution X7 Installation, Support, And Maintenance Manual

1. Connect an RJ-45 to RJ-45 straight through cable, such as the Ethernet cable included, to
LAN 1 port on the X7 Router.
2. Connect the opposite end of the Ethernet cable to an RJ-45 to DB-9 female DTE adapter,
or a USB dongle (such as a Trendnet TU-S9).
3. Connect to a PC running terminal emulation software.
PC serial port settings should be:
• asynchronous mode
• 9600 baud
• eight (8) data bits, no (N) parity bit, and one (1) stop bit, (9600/8-N-1)
The signal and pinouts for the asynchronous serial Console port (RS-232) of the X7 Router and
an RJ-45 to DB-9 female DTE adapter are listed in
Female DTE adapter is shown in
Console Port
(DTE)
RTS
DTR
TxD
GND
GND
RxD
DSR
Rx-RF-Power
Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
Figure D-8 on page

Table D-3. RJ-45 to DB-9 Pinouts

RJ-45 Pin Color Code
1 Blue
2 Orange
3 Black
4 Red
5 Green
6 Yellow
7 Brown
8 White/Grey
Console Port Connection
Table D-3. A picture of the RJ-45 to DB-9
40.
RJ-45 to DB-9
Terminal Adapter
8
6
2
NC
5
3
4
9
Console
Device
CTS
DSR
RxD
GND
GND
TxD
DTR
Not Connected
39