Programming The Virtual 16-Channel Voip Gateway Card; Assigning The Hunt Pattern - Panasonic KX-TDE100 Getting Started

4.2 Programming the Virtual 16-Channel VoIP
Gateway Card
There are 2 methods to programme the Virtual 16-Channel VoIP Gateway Card (V-IPGW16 card) to
establish VoIP communications between PBXs at different locations, as follows:
PBX code
method
Extension
number method
Note
For a detailed explanation about each method, refer to "1.30 Networking Features" in the Feature
Guide.
4.2.1

Assigning the Hunt Pattern

The hunt pattern determines how to route incoming calls through virtual IP trunks to the PBX. The procedure
below demonstrates the process of programming the hunt pattern of the local PBX. After the hunt pattern
at the local PBX has been fully assigned, repeat the procedure for the hunt pattern at the remote PBX with
the appropriate setting values.
Note
For more details about hunt pattern assignment, refer to "2.8.13 [1-1] Slot—Virtual IP Gateway Shelf
Property—Hunt Pattern" in the PC Programming Manual.
The caller dials the unique PBX code of the PBX to which the called party is
connected, in addition to the destination number.
The caller dials only the destination number of the called party to call through
PBXs at different locations (hence there are fewer digits to dial than with the PBX
code method).

4.2 Programming the Virtual 16-Channel VoIP Gateway Card

1. a.
Under Configuration, click Slot.
b.
Move the mouse pointer over the white PBX
image of IPCMPR Virtual Slot at the bottom of
the screen.
c.
Click Select Shelf.
d.
Move the mouse pointer over the installed V-
IPGW16 card. A menu will be shown under the
mouse pointer.
e.
Click Shelf Property.
f.
Click Hunt Pattern.
2. a.
When using the PBX code method:
In the Leading Number box, type the local PBX
code and extension starting digit.
When using the extension number method:
In the Leading Number box, type the local
extension starting digit.
b.
Click OK to return to the Shelf Property screen.
Getting Started for Virtual IP Cards 29