Panasonic KX-TDE100 Getting Started page 25

When using a DHCP server:
When not using a DHCP server:
IMPORTANT
• Do not change the IP addresses of the IPCMPR and DSP cards once IP telephones are
registered to the PBX using these IP addresses.
The IP telephones will not operate properly if these IP addresses are changed.
• A DHCP server must be able to use a "client identifier" option specified by RFC 2131.
• The PBX will not start properly if the IP addresses cannot be assigned automatically by the
DHCP server when DHCP Client is set to Enable. In this case, you need to consult your
network administrator because the DHCP server on your network may not be running or a
network failure may have occurred. If the DHCP server is not available, change the DHCP
Client setting to Disable and set fixed IP addresses, then restart the PBX.
To change the DHCP Client setting, connect the PC with an RS-232C cross cable or Ethernet
straight cable. When connecting the PC with an Ethernet straight cable, make sure the PBX
is disconnected from the LAN and then connect the PC with an Ethernet straight cable
using 192.168.0.101 for the IP address of the IPCMPR card.
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*3 Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and
255.255.255.255)
*4 Valid IP address range: "1.0.0.0" to "223.255.255.255"
a.
Select Enable for the DHCP Client setting.
b.
Click Apply.
Note
The boxes will turn grey and the IP addresses will
be assigned automatically after the PBX is reset.
a.
Select Disable for the DHCP Client setting.
b.
In the IP Address for IPCMPR Card box, type the
IP address of the IPCMPR card.
c.
In the IP Address for VoIP-DSP box, type the IP
address of the DSP16 or DSP64 card.
d.
In the Subnet Mask box, type the subnet mask
address of the network.
e.
In the Default Gateway box, type the IP address of
the default gateway.
f.
Click Apply.
The system menu appears.
Getting Started for Virtual IP Cards
4.1 Programming the PBX
*1
*2
*3
*4
25