Installation Procedure - Omega FUZZY LOGIC CN4800 Manual

4.2 INSTALLATION PROCEDURE

ogy Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE |
Panel
Clamping screw
Panel mounting bracket (accessorie)
For CN4800
• For CN4800
Slide the enclosed plastic panel mounting bracket (shipped with
the CN4800) up the back of the controller until it makes contact
with the back of the panel. Push the mounting bracket until the
tabs seat themselves in the molded tab ridges, located on the
front of the controller's outer case. Tighten the two screw on the
mounting bracket for added pressure; do not use excessive
force.
• For CN4810/20
The mounting bracket's tabs fit into the two holes on both the top
and bottom of the controller's outer case. With an instrument
screwdriver, turn the screw in the mounting bracket until the end
of it touches the back of the panel. Do this to both brackets.
Making sure that the face of the controller is flush and straight,
tighten both mounting bracket screws. Your controller should
now be firmly set. If the controller is still loose, tighten the
mounting bracket screw a little more. Do not use excessive
force.
Panel mounting bracket (accessorie)
Panel
Main unit
9
Clamping screw
For CN4810/20