Table of Contents
Advertisement
3. CHANGING PARAMETERS
1. Display the parameter to be set (to be changed) on the screen, as
described in the Section 2. "Viewing Parameter" (page 33).
2. Select the digit to be set (to be changed ), with the
selected digit flickers).
3. Set (to be changed ) the data with the
4. Press the
flickering (the set (changed) data is registered).
NOTES: If no operation is made for about one minute during data
ogy Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE |
SEL
key, or repeat pressing the
setting (changing), control automatically returns to the
operation mode. The data being changed (set) at this time is
invalidated.
and
35
key (the
keys.
key until it stops
Advertisement
Table of Contents
