Table of Contents
Advertisement
When using the start/reset function, connect an external terminal with
reference to the section "5. Wiring" starting on the page 19. The
operations will be as follows. External contact input takes place at the
time when the contact status (ON/OFF) changes (edge detection).
NOTE:
1. Do not use the auto-tuning function while the ramp soak function is
ON ("
2. The ramp soak command "
supply is switched
ogy Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE |
External contact
(digital input DI)
ON → OFF
OFF → ON
" is not
.
Operation
Program stops.
Program runs.
).
" will be set off, once the power
63
Advertisement
Table of Contents
