Table of Contents
Advertisement
4. Detection of the heater current requires the following current
transformer (to be purchased separately).
5. Heater break alarm is not available in the following cases.
1) Control output 1 is SSR drive output or current output.
2) Control output 1 is relay (1c contact) output and the heater is ON
on the contact N.C. (normally close) side.
3) The output proportion cycle time of control output 1 is lower than
20 seconds.
ogy Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE |
Heater current value
For 1~30A
For 20~50A
59
Types
CTL-6-SF
CTL-12-S36-8F
Advertisement
Table of Contents
