Table of Contents
Advertisement
2. 2-POINT (ON-OFF) CONTROL
When PID control is specified as the control type, setting P to 0.0
provides the 2-point (ON-OFF) control operation.
3. FUZZY CONTROL
Employing Fuzzy Logic control eliminates system overshoot and
effectively suppresses fluction of the process variable due to external
disturbances. See the section describing control type setting (page75).
NOTES
1. The dual output type does not allow use of fuzzy control.
2. Though the fuzzy control also requires setting of parameters P, I,
and D, these values can be set to those being used in PID control.
Auto tuning is also available.
4. DUAL CONTROL
* This function is an option.
If the process heats itself, cooling control is needed in addition to
heating control. The dual control is used for control of that process.
ogy Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE |
(2-point operation hysteresis)
Output OFF
Set the 2-point operation hysteresis
with engineering values. (0~100%
FS D.E.U.)
HYS
Set point
53
Output ON
PV
Advertisement
Table of Contents
