How To Start - Use - Stop The Engine - Castelgarden P 350 Manual

8
EN
REFUELLING
DANGER!
!
Never smoke whilst refu-
elling and avoid inhaling the petrol fumes.
WARNING!
!
Carefully open the tank
top as pressure could have formed inside.
Before refuelling:
– Shake the fuel mixture container well.
– Place the machine on a flat stable surface,
with the fuel tank cap facing upwards.
– Clean the fuel tank cap and the surrounding
area to avoid any dirt from entering the tank
during refilling.
– Carefully open the fuel tank cap to allow the
pressure inside to decrease gradually. Use a
funnel to refill and avoid filling the tank to the
brim.
WARNING!
!
Always close the fuel tank
cap firmly.
WARNING!
!
Immediately clean all tra-
ces of fuel which may have dripped on the
machine or the ground and do not start the
engine until the petrol fumes have dissipated.

6. HOW TO START - USE - STOP THE ENGINE

STARTING THE ENGINE
WARNING!
!
The engine must be start-
ed in an area at least 3 metres from where
you refilled the fuel tank.
Before starting the engine:
– Place the machine firmly on the ground.
– Take off the bar cover.
– Make sure the bar is not touching the ground
or any other object.
• Cold starting
NOTE
A "cold" start of the engine
PREPARING TO WORK / HOW TO START - USE – STOP THE ENGINE
CHAIN LUBRICANT
IMPORTANT
Only use special oil for chain
saws or adhesive oil for chain saws. Do not use
oil containing impurities so as not to block the oil
filter and to prevent irreparable damage to the oil
pump.
IMPORTANT
The special oil for lubricat-
ing the chain is biodegradable. Use of a mineral
oil or engine oil causes serious damage to the
environment.
It is essential that you use good quality oil to
lubricate the cutting parts effectively. Used or
poor quality oil does not guarantee good lubri-
cation and reduces the duration of the chain and
bar.
It is always worth topping up the oil tank com-
pletely (using a funnel) every time you refuel.
Since the oil tank capacity is enough to guaran-
tee that the fuel runs out first, you will avoid the
risk of operating the machine without lubricant.
means starting it after at least 5 minutes from
when it was switched off or after refuelling.
To start the engine (Fig. 12):
1. Check that the chain brake is engaged (with
the front hand guard pushed forward).
2. Set the switch (1) to «START».
3. Pull out the choke (2).
4. Press the primer 3-4 times to aid starting.
5. Hold the machine firmly on the ground, with
your hand on the handgrip and your foot in
the rear handgrip, to avoid losing control dur-
ing starting (Fig. 13).