6-5
Troubleshooting
Motor Drive Faults
The display on the motor drive located inside the electrical enclosure alerts
the operator to abnormal motor drive/motor operation. Motor drive faults
cause the pump to stop. Table 6‐3 lists the motor drive fault codes.
To clear the motor drive faults shown in Table 6‐3, correct the problem that
caused the fault and then remove power from the motor drive by turning the
heaters off. Wait until the motor drive display is completely blank before
restoring power.
Figure 6-1
Location of the motor drive display
Part 1107600_03
E 2014 Nordson Corporation