Nordson AltaBlueA4TP Customer Product Manual page 99

Component keys
E 2014 Nordson Corporation
To adjust the setpoint temperature using the global‐by‐component
method
1. Press and hold the Hose or Gun key for three seconds.
The left display indicates the number of the first sequential hose or
gun. The right display indicates the current setpoint temperature of the
hose or the gun.
2. Scroll the left display to 0.
The right display indicates all dashes (‐ ‐ ‐ ‐).
3. Press the Enter key.
The right display flashes.
4. Use the keypad to enter the setpoint temperature recommended by
the manufacturer of the hot melt. Refer to the technical data
sheet provided by the manufacturer of the hot melt to determine the
optimal setpoint temperature.
NOTE: If the keypad or the right‐display scroll keys have no affect on the
right display, the melter is password protected. You must enter a valid
password before you can change setpoint temperatures. Refer to
Entering the Melter Password later in this section.
5. Press the Enter key.
The hoses or the guns begin to heat or cool to their new
setpoint temperature.
4-25
Operation
Part 1107600_03