Pump Or Motor Not Working - Nordson 3400 Manual

Pump or Motor Not Working

Problem
1. Pump not turning but motor
running
2. Motor fails to start
E 2000 Nordson Corporation
All rights reserved
WARNING: Risk of electrical shock. Failure to observe
electrical safety procedures may result in equipment damage,
personal injury, or death. Allow only qualified personnel to
perform electrical troubleshooting. Observe all high voltage
indicators.
Possible Cause
Misaligned, damaged, or loose chain
or damaged or worn sprockets
Melter not at operating temperature
Motor speed control dial set at 0
Blown fuse
Failed motor control interface board
Failed motor drive board
41-3000
Issued 11/00
Pump
Corrective Action
Check the motor chain and sprockets.
Refer to Motor Chain and Sprocket
Check.
Wait for the time delay to expire and
the SYSTEM READY light to turn on.
Change the setting.
Remove the electrical enclosure lid
and check the input power neon on
the motor control interface board. If
the neon is off, replace the fuses.
Measure the input voltage to the
motor control board at J2-6 and J2-8
on the motor control interface board.
If you do not measure line voltage,
replace the motor control interface
board.
Measure the voltage at the motor
drive board A+ (red wire no. 31) and
A- (black wire no. 31) wires. If the
voltage is less than 10 VDC, replace
the motor drive board.
Continued on next page
B2EN-02-[3-PUMP]-5
B 2-7