Password Entry; Password Change - AUMA SQ Series Operation Instructions Manual

Operation
Password
6.4.1.

Password entry

6.4.2.

Password change

Select main menu
38
SQ 05.2 SQ 14.2 / SQR 05.2
There are 6 different user levels. The user level is indicated in the top row:
Figure 34: User level display (example)
A password must be entered to allow parameter modification. The display indicates:
Password 0***
A specific password is assigned to each user level and permits different actions.
Table 23:
User levels and authorisations
Designation (user level)
Observer (1)
Operator (2)
Maintenance (3)
Specialist (4)
Service (5)
AUMA (6)
1. Select desired menu and hold down push button
Display indicates the set user level, e.g Observer (1)
2.
Select higher user level via
Display indicates: Password 0***
3. Use push buttons
4. Confirm first digit of password via push button
5. Repeat steps 1 and 2 for all further digits.
Having confirmed the last digit with
user level is possible if the password entry is correct.
Only the passwords of same or lower access level may be changed.
Example: If the user is signed in as Specialist (4), he/she can change passwords as
for password levels (1) through (4).
Device configuration M0053
Service functions M0222
Change passwords M0229
Menu item Service functions M0222 is only visible, if user level Specialist (4) or higher
is selected.
1. Set selector switch to position 0 (OFF).
SQR 14.2 Control unit: electronic (MWG)
Authorisation/password
Verify settings
No password required
Change settings
Default factory password: 0000
Reserved for future extensions
Change device configuration
e.g. type of seating, assignment of output contacts
Default factory password: 0000
Service staff
Change configuration settings
AUMA administrator
Up ▲ and confirm with
Up ▲ Down ▼ to select figures 0 to 9.
Ok, access to all parameters within one
AC 01.2 Non-Intrusive Profinet
for approx. 3 seconds.
Ok.
Ok.