Step 2: Install The Cutting Tool - Roland VersaUV LEC2-300 Setup Manual

3. Installing the Cutting Tool

Step 2: Install the Cutting Tool

1.
Enter the "REPLACE BLADE" menu.
A
Press [MENU].
B
Press [ ] several times to display the screen shown below.
MENU
SUB MENU
C
Press [ ] once, and then press [ ] several times to display the screen shown below.
SUB MENU
MAINTENANCE
D
Press [ ] once, and then press [ ] several times to display the screen shown below.
MAINTENANCE
REPLACE KNIFE
E
Press [ENTER].
The cutting carriage moves to a position where blade replacement is possible.
F
When the following screen is displayed, open the front cover.
OPEN FRONT
Preparations are complete when this screen appears.
FINISHED?
2.
Install the cutting tool.
A
Loosen the cutting carriage screw.
42
2.Installation
COVER