Step 1: Assemble The Stand And Mount The Machine On The Stand - Roland VersaUV LEC2-300 Setup Manual

Step 1: Assemble the Stand and Mount the Machine on the Stand

WARNING
CAUTION
Procedure
A
Attach the stand stay to the stand legs.
Position the stand legs so that their U-shaped brackets face the inside, and then tighten the bolts
securely (eight locations in total) in the order shown below. Loose bolts may cause the stand to wobble.
Temporarily tighten the bolts in the two upper locations. (On the left and right sides for
a total of four locations.)
Temporarily tighten the bolts in the two locations on the sides. (On the left and right
sides for a total of four locations.)
Fully tighten the bolts in the two upper locations. (On the left and right sides for a total
of four locations.)
Fully tighten the bolts in the two locations on the sides. (On the left and right sides for a
total of four locations.)
Tighten temporarily
→ tighten fully
Bolts: 8
Washers: 4
Position the stand legs
so that the U-shaped
brackets face the inside.
Place the stand stay on the stand legs as shown in the following figure.
Make this gap
uniform.
Perform this task with all power switches left switched off.
Failure to observe this instruction may cause the machine to move suddenly,
resulting in injury.
Unloading and emplacement are operations that must be performed by 6 persons
or more.
Tasks that require undue effort when performed by a small number of persons may
result in physical injury. Also, if dropped, such items may cause injury.
Hexagonal
wrench
Bolt
Washer
Stand leg
Side
Stand stay
Stand leg
2. Assembly and Ink Filling
Hexagonal
wrench
Bolt
Stand stay
Top
Align these parts
so they are parallel.
Stand leg
Washer
Stand stay
2.Installation
25