Installing The Cutting Tool; Assembling The Cutting Tool - Roland TrueVIS LG-640 Setup Manual

2. Installing the Cutting Tool

This operation is unnecessary if you will not use the cutting tool. Tighten the cutting carriage screw lightly
when no cutting tool is installed. Keeping the screw firmly tightened causes the cutting tool insertion hole
to become gradually smaller, making installation difficult.
WARNING
Be sure to perform operations as specified by the instructions, and never touch any area not
specified in the instructions.
Sudden movement of the machine may cause injury.
CAUTION
Never touch the tip of the knife.
Doing so may result in injury. The cutting performance of the blade will also be impaired.

Assembling the Cutting Tool

Procedure
1.
Insert the pin.
Insert the pin until the tip protrudes about 3 to 5 mm (0.12 to 0.20 in.).
2.
Insert the blade.
Insert the blade into the hole so the blade tip is on the outside.
47
Installation