Table of Contents
Advertisement
b) Remove the filter from the gap between the prism holder and its base.
c) Unhook the fitting at the top of the optical filter from the prism holder.
Projecting part (bottom)
Grasp here with tweezers
8. Re-install the front cover.
9. To prevent dust from entering the lens mount, insert a dust cover.
Installing the supporting brackets
The supporting brackets are required when using the ultra short throw fixed lens.
Required components
The following components are required to install the supporting brackets.
•
1 support bracket (mount bracket A)
•
1 lens mount bracket (mount bracket B)
•
4 M6x16 hex-head screws
•
2 M4x10 screws
•
2 collars
•
1 hex key
Optional Lenses D Series and LW551i Installation and Setup Manual
020-102490-02 Rev. 1 (04-2017)
Copyright
2017 Christie Digital Systems USA Inc. All rights reserved.
©
Front cover (upper part)
Front cover (lower part)
Installing the ultra short throw fixed lens
Prism holder
Base of prism
18
Advertisement
Table of Contents
