Installing the projector on a table top
Learn how to install the projector with an ultra short throw fixed lens on a table top.
1. To attach the support bracket to the projector, tighten the four M6×16 hex-head screws in the
order shown below and torque to 1.96 Nm (20kgf·cm).
M6×16 hex-head screws
2. Flip the projector over.
3. To adjust to the correct screen position, use the vertical and horizontal shift adjustments.
When adjusting the vertical and horizontal shift, always loosen the screw. Adjusting the
vertical and horizontal shift without loosening the screw can damage the product.
4. When the screen is in position, firmly tighten the screw until it is locked in place.
Screw
Mounting the projector on the ceiling
Learn how to mount the projector with an ultra short throw fixed lens on a ceiling.
1. To mount the bracket of the ceiling mount to the projector and the mount bracket A, use the
four M6×35 hex-head screws.
Optional Lenses D Series and LW551i Installation and Setup Manual
020-102490-02 Rev. 1 (04-2017)
Copyright
2017 Christie Digital Systems USA Inc. All rights reserved.
©
M6×16 hex-head screws
Installing the ultra short throw fixed lens
22