Table of Contents
Advertisement
To center the lens in standby mode, on the control panel, press FUNCTION and LENS SHIFT
at the same time for three seconds.
2. Turn off and unplug the projector.
3. Allow the projector to sufficiently cool down.
4. To remove the front cover, move and slide the cover up while pressing the front cover from the
underside and remove the front cover from the projector.
5. To remove the lens:
a) Support the lens.
b) Lower the lens lock lever to the lowest position.
c) Remove the lens from the projector.
To avoid any malfunctions, ensure the surface of the lens does not come in contact with
the projector.
Lens lock lever
You can move the lever while the upper plate touches the lower plate.
6. Attach the lens cap to the lens.
7. Remove the optical filter:
a) Using a pair of tweezers, grasp the part sticking out at the bottom of the optical filter.
Optional Lenses D Series and LW551i Installation and Setup Manual
020-102490-02 Rev. 1 (04-2017)
Copyright
2017 Christie Digital Systems USA Inc. All rights reserved.
©
Front cover (upper part)
Front cover (lower part)
Installing the ultra short throw fixed lens
17
Advertisement
Table of Contents
