Noraxon Ultium EMG User Manual page 17

Ultium Footswitch SmartLead User Manual
7.6.2 Find My Sensor Feature
Find my Sensor allows the user to quickly locate a specified Ultium sensor while creating/editing a MR3
configuration (refer to section 7 for guidance on how to create or edit a configuration). If one of the
stars (refer to the figure below) is clicked, the corresponding sensor will repeatedly blink light purple in
bursts of 3. If the topmost star is clicked, every sensor that is currently in the configuration will execute
the same blinking pattern.
(Rev C May 2019)
sensor (redetection is
necessary to revert to the use
of the sensor's EMG
functionality). This will prevent
configuration errors leading to
the inability to collect a
measurement. If an error
message pops up when
starting a measure, and you are
using SmartLeads, this is a
good first troubleshooting step
(1. Redetect sensors in
hardware set-up; 2. Double
check the configuration).
* See Find My Sensor section
below
Step 5
Once the Ultium system is
inserted, the muscle map will
appear to the left, and the EMG
channels and sensors will
appear below. The Footswitch
SmartLead should
automatically appear, as
detected by the Ultium system
(if it does not – refer to step
2a).
To select the Footswitch for
use in a recording, check the
box next to the Footswitch
channel to be recorded.
17