Noraxon Ultium EMG System Quick Start Manual
Hide thumbs
Also See for Ultium EMG System:
- User manual (51 pages) ,
- Quick start manual (12 pages) ,
- Quick start manual (8 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Noraxon Ultium EMG System
Summary of Contents for Noraxon Ultium EMG System
- Page 1 Ultium EMG Quick Start Guide Ultium™ EMG System Quick Start Guide Quick Start Guide Quick Start Guide Quick Start Guide (Rev A)
-
Page 2: System Unboxing
Note: This is not meant to be a complete manual, but a guide to help you get started with your system. For more detailed instructions on operating the Ultium EMG System and its features please refer to the complete Ultium User Manual (P-8808), also included with your system. - Page 3 Ultium EMG Quick Start Guide Figure 6 - A to B USB Cable (part #CBL2) Figure 5 - EMG Sensor Charger Power Source (part #PSU1) Figure 8 – Sensor Docking Station to Ultium Receiver cable (part# CBL34) Your system may differ depending on the number of sensors included with your shipment, quantities of EMG sensors, EMG SmartLeads Sensor Docking Stations, and Docking Station Cables.
-
Page 4: Installing The Hardware
Ultium EMG Quick Start Guide 2 Installing the Hardware Step 1 Insert the USB-B (smaller) end of the USB cable (CBL2) into the USB connector on the rear of the Ultium Receiver (880). Insert the opposite end of the USB cable into an available USB port on the computer. - Page 5 Ultium EMG Quick Start Guide Insert the power supply (PSU1) barrel connector into the jack of the Ultium Receiver. Step 5 Connect the Receiver to the Sensor Docking Station (883). This will charge the sensors (Rev A)
-
Page 6: Software Installation
Ultium EMG Quick Start Guide 3 Installing the companion Software - myoResearch™ 3 To utilize the full functionality of the Ultium EMG system, and ensure the system has updated drivers, Noraxon’s myoResearch 3 (MR3) needs to be installed on the computer. -
Page 7: Configuring The Hardware
Follow the below instructions to update the receiver firmware, sensor firmware, and populate sensors to prepare for a data collection. Step 1 Open MR3, typically listed under Noraxon -> Click on the Hardware Setup Hardware Setup button in the upper... - Page 8 Ultium EMG Quick Start Guide Step 4 Click the Advanced Tab. Select a RF Network from the RF Network list. In most cases the default “1” will work. However, if using multiple Ultium systems they must be placed on separate networks. You may also set EMG filter cutoffs here.
- Page 9 Ultium EMG Quick Start Guide Step 7 Click on OK (in the bottom of the dialog box) when done. Note: Sensor serial numbers appear in the order that they are placed in the charging doc, starting at the end with the LEDs (opposite of the charging port).
-
Page 10: Recording A Measurement
Ultium EMG Quick Start Guide 5 Recording a Measurement Step 1 Within the Home screen, click on the myoMUSCLE module icon. Create a New Subject Select New Configuration. New Configuration. New Configuration. New Configuration. Step 2 Insert the devices to be used for the measurement into the configuration by dragging a device in from the list of Available Available... -
Page 11: Viewing A Record
Ultium EMG Quick Start Guide 6 Viewing a Record To view a previously recorded record, select the Database Database Database tab. Records are organized by Project Database Project Project Project and Subject Subject name. Double click on the record of interest to open the record in the Viewer Subject Subject Viewer...