Table of Contents
Advertisement
12. Connecting to other equipment
Saving Pictures and Videos on a Recorder
You can connect the camera to an accordingly equipped Blu-ray disc or DVD recorder and
store pictures and videos on it.
1
Connect the recorder and camera with the USB cable.
• Before connecting, turn on the camera and the recorder.
• Check the plugs orientations and insert them straight. (If they are inserted in the wrong
direction, the plug and socket pins could be bent and cause faulty operation.) Also, do
not insert into the wrong socket. Doing so may damage the camera.
• Do not use any other USB cables except the supplied one.
• A message about charging may be displayed. Wait until the display disappears.
A [USB/CHARGE] socket
B USB cable
2
Press 3/4 to select [PC(Storage)], and then [MENU/SET].
• If you set the [USB Mode] to [PC(Storage)] in the [Setup] menu, the [USB Mode]
selection screen will not be displayed and the camera will automatically connect to the
recorder.
3
Operate the recorder to copy.
• See the instructions for the recorder about the details about copying and playing back.
• Modes such as 4K video may not be supported depending on the recorder being used.
• Use a sufficiently charged battery or the charger. If the remaining battery power becomes low
while the camera and the recorder are communicating, the alarm beeps. In that case, cancel
copying immediately. Otherwise. damage may be caused to the data.
• Before removing or inserting the card, turn off the camera and disconnect the USB cable.
Otherwise, damage may be caused to the recorded data.
260
Advertisement
Table of Contents
