Table of Contents
Advertisement
12. Connecting to other equipment
Selecting multiple pictures and printing them
1
Press 3 to select the multiple printing setting in step
(>261).
2
Press 3/4 to select an item and then [MENU/SET].
[Multi Select]
[Select All]
[Rating]
3
Press 3/4 to select [Print start] and then [MENU/SET].
• Group pictures will not be displayed as group pictures but as single pictures.
• Disconnect the USB cable after printing.
• Use a sufficiently charged battery. If the remaining battery power becomes low while the
camera and the printer are connected, the alarm beeps. If this happens during printing, stop
printing at once. If not printing, disconnect the USB cable.
• Before removing or inserting the card, turn off the camera and disconnect the USB cable.
Otherwise, damage may be caused to the recorded data.
• Some printers can print directly from the card removed from the camera. For details, refer to
the instructions of your printer.
• The camera is receiving an error message from the printer when the [¥] indication lights
yellow during printing. After finishing printing, make sure there are no problems with the
printer.
• If the number of prints is high, the pictures may be printed several times. In this case, the
remaining number of prints indicated may differ from the number set.
• Only pictures taken in JPEG format can be printed. Those taken in RAW will use the JPEG
pictures that were simultaneously created. If an equivalent JPEG picture is not available, no
print will take place.
Not available in these cases:
• Videos, 4K picture series files, and images recorded with the Post Focus function cannot be
printed.
Multiple pictures are printed at one time.
• Press 3/4/2/1 to select the pictures and then [MENU/SET].
(Press [MENU/SET] again to cancel the setting.)
• After the pictures have been selected, press [DISP].
Prints all the stored pictures.
Prints all images with [Rating] levels between [¿1] and [¿5].
262
3
of "Printing Pictures"
Advertisement
Table of Contents
