Installation Instructions For The Snmp Adapter In A Swt 3000 Device - Siemens SWT-3000 Equipment Manual

SNMP and Remote Access

Installation instructions for the SNMP adapter in a SWT 3000 device:

A DC/DC converter module converts the ± 5V of the SWT 3000 to ± 12V for the SNMP adapter.
Along with the SNMP adapter and the converter module, all necessary cables and
hardware are provided:
A
B
C
D
E
F
G
H
J
K
L
M
N
The figure below shows the wiring diagram for the SNMP adapter:
Figure 7:
Page - 14
1 SNMP adapter
1 Bracket for SNMP adapter
1 Adapter connector for SNMP adapter
1 DC/DC converter module
8 Screws M2,5x20
8 spacers (11mm long)
1 long cable (connects SWT 3000 power source with DC/DC converter)
1 short cable (connects DC/DC converter with SNMP adapter)
2 cable ties
2 cable tie holders
2 plastic rivets
2 slotted screws
8 screws M2,5x8 for SWT 3000 with single power supply higher SNMP adapter
brackets
Wiring diagram
Edition p3_3_2x 08/09
SWT 3000 Equipment Manual
mounting
© SIEMENS AG 2008