Firmware Upgrade With Memtool; General Information; System Requirements; Version Of Memtool - Siemens SWT-3000 Equipment Manual

Chapter 3: Service program PowerSys

Firmware upgrade with MemTool

General information

This description is the upgrade instruction for the controller cards of PowerLink and SWT 3000.
For firmware download of PowerLink and SWT 3000 a dedicated Flash PROM programming tool
can be used. The MemTool flash programming software is provided with the PowerSys CD-ROM
and ensures easy and quick product upgrade if required.
The document describes the upgrade of PowerLink_CSP and SWT 3000_PU3 units in the All In
One mode. Target files are delivered as AllInOne*.jnk. Typically the files are part of the PowerSys
software package available on CD-ROM.

System Requirements

To run MemTool at least the following minimum system configuration is required.
•
•
•
•
•
•
•

Version of MemTool

MemTool release V1.12
Page - 20
IBM Personal Computer or 100% compatible
Pentium (or higher) processor running at 90 MHz with 32 MByte RAM
Operating System Windows 2000 (SP2 or higher), Windows XP
Adobe Acrobat Reader 4.0 or higher
10 MByte space on local hard-disk
CD-ROM drive for installation
Standard serial port interface
Edition p3_3_2x 08/09
SWT 3000 Equipment Manual
© SIEMENS AG 2008