The <Data Source> Menu; Data Source <Device; Data Source <File - Siemens SWT-3000 Equipment Manual

Chapter 3: Service program PowerSys
The <data source> menu
Figure 12:
Table 2:
Selection
Device
Remote device
Disconnect
File
New
Close
Data source <Device>
By selection of "Device" the data are read in from the connected terminal. The program attempts
to establish a connection to the unit (PowerLink or SWT 3000) and subsequently loads the data of
the unit into the system memory of the service PC. Subsequently the downloaded data can be pro-
cessed. The program detects from which unit (PowerLink or SWT 3000) the data were read and
automatically changes to the appropriate program level.
Data source <File>
A sub-menu is opened for selecting the file to be loaded.
Figure 13:
After the file has been loaded, the data can be modified or programmed in the device.
Page - 10
The "Data source" menu
Functions of the data source menu
Meaning
Establishing the connection to the
device
Establishing the connection to a
remote device
Disconnecting the device
Load the parameter from a file
New configuration
Loading the data from an existing file
Edition p3_3_2x 08/09
SWT 3000 Equipment Manual
Select the device
type
Remark
Select the device type
© SIEMENS AG 2008