Advertisement
KINROAD 150 SERVICE MANUAL
FOAM FILTER MAINTENANCE
1. Remove the foam filter from steel cage
2. Wash in non-flammable cleaning solvent
3. Submerge in oil and squeeze to remove excess oil
4. Install the element back into the air box.
1.Before and during cleaning, inspect the element for tears. A torn element must be replaced.
2.Make sure the element is seated properly and no foreign material can pass by it
NUTS AND BOLTS IN THE CHASIS
Inspect first week and every month thereafter.
Always pay attention to the nuts and bolts. Some loosening after use is a normal situation and should be
checked regularly.
TIGHTENING TORQUE TABLE
Bolt
Diameter
(mm)
4
5
6
8
10
12
14
16
18
FUEL SWITCH (PETCOCK)
1.
Periodically clean the petcock externally with grease remover and water.
2.
Check for any leaks or seeping fuel.
3.
Replace the petcock if there are any leaks found.
This vehicle has a manually operated fuel valve. There are three positions.
" RES " " OFF " " ON "
Conventional marked bolt
N・m
Kg・m
1-2
0.1-0.2
1-4
0.2-0.4
4-7
0.4-0.7
10-16
1.0-1.6
22-35
2.2-3.5
35-55
3.5-5.5
50-80
5.0-8.0
80-130
8.0-13.0
130-190
13.0-19.0
8.8 marked bolt
lb-ft
N・m
0.7-1.5
1.5-3
1.5-3.0
3-6
3.0-5.0
8-12
7.0-11.5
18-28
16.0-25.5
40-60
25.5-40.0
70-100
36.5-58.0
110-160
58.0-94.0
170-250
94.0-137.5
200-280
10
VERSION 1, DEC., 2005
Kg・m
lb-ft
0.15-0.3
1.0-2.0
0.3-0.6
2.0-4.5
0.8-1.2
6.0-8.5
1.8-2.8
13.0-20.0
4.0-6.0
29.0-43.5
7.0-10.0
50.5-72.5
11.0-16.0
79.5-115.5
17.0-25.0
123.0-181.0
20.0-28.0
144.5-202.5
Advertisement
