Advertisement
KINROAD 150 SERVICE MANUAL
Assemble the new O-ring on the carbon brush base.
Install armature into starter motor case, making sure not to damage
the carbon brushes.
Tighten motor case bolts.
Make sure the starter motor case is free of metal particles,
because it is magnetic.
Before installing the starter motor on the vehicle after
assembling it, first connect the lead wires and inspect if
the motor runs normally.
Apply oil on the O-ring, and install the starter motor. Tighten holding
bolts.
REDUCTION MECHANISM
The picture shows the structure of the reduction mechanism.
1. Starter reduction gear
2. Starter reduction gear shaft
3. Starting clutch gear comp.
4. Starting clutch outer comp.
5. Flange starting clutch
6. Starting clutch roller spring
7. Spring holder
8. Starter motor
11. Clamp
12. Bolt
13. Nut
14. Washer
15. Dowel pin
16. Key woodruff
17. Roller
18. Needle bearing
43
VERSION 1, DEC., 2005
Advertisement
