Advertisement
KINROAD 150 SERVICE MANUAL
Remove the circlip from the driven plate.
Drive the ball bearing out.
The removed bearing cannot be reused.
Apply some grease on the new ball bearing.
Drive the ball bearing into the driven plate with its front face upwards.
Assemble the circlip.
Apply grease evenly on the inner wall of the driven plate.
Use the prescribed grease.
Drive the new needle bearing into with its mark upwards.
Use the special tool.
Apply grease around the bearing.
DRIVE BELT PULLEY INSTALLATION
Remove the grease on the driven plate.
Assemble the oil seal.
Apply a little grease on the O-ring.
Assemble the movable driven plate into the driven plate.
After applying some grease on the roller and the guide pin,
assemble them into the driven plate hole.
Install the oil seal collar.
Remove the excessive grease.
No grease on the movable face of the driven plate.
Assemble with the clutch and install on the left crankcase.
55
VERSION 1, DEC., 2005
Advertisement
