Advertisement
KINROAD 150 SERVICE MANUAL
TIE ROD
Tie rods should be checked for ease of movement in their
full rotation.
Remove protective boot and apply grease.
Check tie rod ends periodically for tightness at their
adjusting nuts.
Always use a new cotter pin after removal.
REVERSE ADJUSTMENT
1. Press down the reverse lever to the "FW" position so
that the units can move forward. Pull back the lever to
"BW" so that the units can move backward.
2. Adjusting Nut #1 on the top of the reverse cable can
adjust the mesh status inside the reverse gear box. In the
forward position there should be about 1/4 inch play in the
cable for the correct adjustment.
SERVICE AIR CLEANER
Service every 100 hours.
Note: Service more often under dusty conditions.
1. Remove cleaner cover.
2. Remove air cleaner element 2.3.
TO SERVICE-PRE-CLEANER
1. Clean foam filter with no-flammable cleaner. If filter is paper, tap filter on an object, knocking dust from
filter or replace with new filter.
2. Dry filter after cleaning, then dip it into engine oil specified by the manufacturer and wring excess oil out
of filter.
78
VERSION 1, DEC., 2005
Advertisement
