Advertisement
KINROAD 150 SERVICE MANUAL
Reverse the removal procedure for installation.
When installing the flywheel, make sure there are no metal pieces, such as bolts or nuts,
attaching to the inner wall of the flywheel.
After the installation is finished, start the engine to inspect and adjust the ignition timing.
REGUALTE RECTIFIER
MAIN WIRING-SUB ELECTRIC CIRCUIT CONDITION INSPECTION
Take the voltage regulate rectifier inspection procedure by two steps:
First inspect he main wiring—sub electric circuit condition, and then inspect the voltage regulator.
Inspect only when engine is cold.
Remove the 4-core connector of the regulate rectifier.
Measure the conducting status between the main wiring terminals according to the previous wiring diagram.
Connecting type
Battery (the red wire) –Vehicle body
Connecting wire (the green wire) –Vehicle body
Lighting wire (the yellow wire)—Vehicle body
(remove the resistor, side auto-starter plug, and
turn the lighting switch to OFF)
Charging wire (the white wire)—Vehicle body
W (White)
Y (Yellow)
Normal condition
Battery voltage value
Conductive
Generally is 0.1-0.8Ω
Generally is 0.2-2.0Ω
R (Red)
68
VERSION 1, DEC., 2005
G (Green)
Advertisement
