Advertisement
KINROAD 150 SERVICE MANUAL
"ON" position
The normal operating position for the fuel valve lever is the "ON" position.
In this position, fuel will flow to the carburetor.
"RES" position
If the fuel lever in the fuel tank becomes too low for the engine to operate
with the fuel valve lever in the "ON" position, turn the lever to the "RES"
position to use the reserve fuel supply, and refuel as soon as possible.
"OFF" position
The closing position for the fuel valve lever is the "OFF" position.
When the vehicle is not in use, always make sure the petcock is in the "OFF" position
FINAL GEAR OIL
Inspect monthly and change quarterly.
1.
To check the oil level, remove the level screw on the left rear engine
case.
2.
To drain oil, remove the drain plug at the rear bottom of the engine
case. It is recommended to warm the engine for 10 minutes or more
before draining final gear oil.
NOTE:
Mobil 85w/90 gear oil is recommended in the final drive case. However, in extreme cold weather conditions,
you may experience the vehicle to be hard to start. It is then advised to use lighter viscosity oil, such as 75
wt, or equivalent motorcycle transmission fluid.
Gear Oil Capacity
0.2L
85w/90
11
VERSION 1, DEC., 2005
Advertisement
