Advertisement
KINROAD 150 SERVICE MANUAL
SPIRAL SPLINE TRANSFERRING STYLE STARTING MECHANISM INSTALLATION
Assemble the starting idle shaft set. Before assembling, apply
a little grease on the bore of the idle shaft.
Assemble the starting spindle, the return spring, and the
spring holder pin. A little grease should be applied on the part
of the starting spindle.
Align the idler shaft holding pin with the groove of the
crankcase, then put it in.
Before installing, apply a little grease on the groove of
the rotary retaining spring on the idler shaft.
The rotary retaining spring should be aligned with the
specific groove of the crankcase to install.
Align the scribing mark of the starting spindle with the punching
mark of the idle shaft, and then assemble the starting spindle.
Hook on the two ends of the return spring.
Install the return spring stopping plate.
Install the crankcase dowel pin, gasket.
Install the driven belt, the driving plate.
Install the left crankcase cover and lock tightly.
Install the starting pedal.
40
VERSION 1, DEC., 2005
Advertisement
