Advertisement
KINROAD 150 SERVICE MANUAL
Install the partition board and tighten bolts.
Install the starting reduction gear, starting clutch
Assemble the gasket, dowel pins.
Assemble the right crankcase cover-positioning bolt
Assemble the trigger winding and the stator coil.
Tighten the right crankcase cover positioning bolt.
The bolt should be gradually diagonally tightened in two to
three steps.
After finishing the installation, inspect for any oil leakage.
FUEL SUPPLY SYSTEM INSPECTION AND SERVICING
CARBURETOR IDLING ADJUSTMENT
AIR ADJUSTING SCREW ADJUSTMENT
Step one: Turn on the air adjusting screw in, then turn out by the prescribed number of turns.
Turn out numbers of turns
Step two: Adjust the throttle adjusting screw to the prescribed idle rpm.
Step three: Adjust the air adjusting screw slightly to find the highest position of the rpm.
Add throttle quickly and gently (the rpm is from low to high), and return throttle immediately, then
observe for 10 to 15 minutes to find the idle remains the same.
3 1/8 +/- 3/4
34
VERSION 1, DEC., 2005
Advertisement
