• If you are using an extension cord or a portable electrical outlet device (eg multi-socket outlet
• Do not touch or operate the washer with wet hands or with bare feet.
• A damaged power cord must be replaced by a Fisher & Paykel trained and supported service
• Do not operate this washer if it has been damaged during transport. Contact your Fisher &
Spare Parts*
Hose inlet long (2m)
Hose inlet large bore
Drain hose extension (not suitable for attaching to a spigot)
*Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported service technician.
Completing the Installation
Installation Test Cycle
Do this before you wash any items in your washer. This is to check that your washer is installed
correctly and that it is functioning properly prior to use. We recommend you complete an initial
manual cycle with an empty drum and half a dose of detergent in order to remove any residues from
the manufacturing process.
1. Turn your washer on by pressing the 'POWER' button.
2. Select 'Manual' and put half a dose of detergent into the 'Manual Dose' compartment.
3. Select the 'Quick 30' cycle. Ensure the drum is empty and the door closed.
4. Touch the
button. The washer will start to fill.
◦ Observe the washer for any problems (eg leaking from the hoses, excess noise or vibrations).
◦ The washer will beep and display any faults on the screen if there are any problems. Refer to the 'Before
https://producthelp.fisherpaykel.com/nz/Wash/Front_Loaders/FabricSmart/WH1260F1/User_Guide_WH1260F1/03_Installatio...
box), ensure that it is positioned so that it does not come into contact with water or moisture.
FAILURE TO DO SO MAY RESULT IN DEATH OR ELECTRICAL SHOCK.
technician or similarly qualified person in order to avoid a hazard. Do not use the appliance until
it has been repaired to avoid a risk of electric shock.
Paykel dealer or Fisher & Paykel trained and supported service technician.
Part No.
422680P
426123P
425627P
Updated: Thu, 20 Feb 2020 12:39:38 GMT
Powered by
11