Completing Your Installation; Installation Test Cycle - Fisher & Paykel WA8060P Installation Instructions Manual

Completing your installation

• Turn on the water and check all hose connections for leaks. Make sure there are no kinks in the hoses. Check
the hose connections for leaks again after 24 hours.
• Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
• Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
Do not touch or operate the washer with wet hands or with bare feet.

Installation test cycle

Your washer must be correctly installed before use. Check the installation and operation of the washer using the
following procedure:
1. Touch 'POWER' to activate your washer.
2. Touch both the and 'Options' buttons at the same time, and hold for three seconds.
3. Touch to start the installation test cycle. The display will show and the lid will lock.
4. The washer will beep to signal the end of the installation test cycle. If there are no faults found, the washer will
automatically turn off at the end of the installation test cycle. Any faults will be displayed on the screen (refer to
the back of this user guide to help identify faults). If you need further assistance, please contact a Fisher &
Paykel trained and supported service technician or our Customer Care Centre. Refer to
section for contact details.
Note: if there are no faults found, the washer will automatically turn off at the end of the installation
test cycle.
ACCESSORIES AND SPARE PARTS
https://producthelp.fisherpaykel.com/au/Wash/Top_Loaders/FabricSmart/WA8560P1/User_Guide_WA8560P1/03_Installation...
• Keep your spirit level for the next time you move or reposition your washer.
• If moving or transporting your washer in the future, ensure you tape the lid down
beforehand.
'Customer Care'
Updated: Wed, 26 Feb 2020 08:47:21 GMT
Powered by
9