Table of Contents
Advertisement
Attaching Drain Hose to Spigot
1. Guide the drain hose through the hose guide.
2. Secure the hose guide to the back wall of
cupboard using a screw. The height of the drain
hose should be between 600 – 1000mm from
ground level.
3. Attach the drain hose to the spigot and secure
using a hose clamp to ensure the blanking
insert is cleared from the spigot.
4. Check for leaks
• The drain hose should be checked from
time to time and replaced if any damage
(eg wear, cuts, bulges, kinks, leaks, etc) is
found. Do not bend the drain hose
sharply, as this may cause it to split.
• In multi-storey apartments or any upper
floor, the washer should be installed on a
floor equipped with a drain.
• Draining must comply with local by-laws.
Electrical Connection
1. This appliance must be connected to a 220V – 240V, 50Hz, sinusoidal, minimum 10A electrical supply.
2. Release the power cord (transit bolts must be removed).
3. Remove and discard the plastic pin cover and plug into a wall socket.
4. Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
• Check the power cord for damage and make sure it is not squashed or twisted when installing the washer.
• Always remove the power cord from a socket by the plug, not by the cord.
https://producthelp.fisherpaykel.com/nz/Wash/Front_Loaders/FabricSmart/WH1260F1/User_Guide_WH1260F1/03_Installatio...
Attaching drain hose to spigot
Updated: Thu, 20 Feb 2020 12:39:38 GMT
Powered by
10
Advertisement
Table of Contents
