Levelling The Washer; Connecting To The Water Supply; Inlet Hoses - Fisher & Paykel WH1260F1 Installation Instructions Manual

Hide thumbs Also See for WH1260F1:

Table of Contents

Levelling the Washer

It is IMPORTANT to level the washer to ensure good spin performance,

and to minimise noise, vibrations and wear and tear on the washer.

1. Before positioning the washer in its final position, check that it

is level, front to back and side to side.

2. Adjust the product into its final position (we suggest a minimum

clearance of 20mm each side).

3. Use a spirit level to check that the washer is correctly level. If

needed, pull the washer out. Loosen the lock nut using the

spanner provided and wind the feet up or down to correctly

level the washer.

4. Using the spanner provided, tighten the lock nuts against the

base of the washer to lock the feet in position.

• Use new hose sets provided with the washer to connect the washer to the water mains.

• Old hose sets should not be re-used.

• We recommend the inlet hoses are changed every 5 years.

https://producthelp.fisherpaykel.com/nz/Wash/Front_Loaders/FabricSmart/WH1260F1/User_Guide_WH1260F1/03_Installatio...

Failure to do so may result in a flood and damage to property.

Locking the feet

Updated: Thu, 20 Feb 2020 12:39:38 GMT

Table of Contents