Curve Diagram; Signal Table - Siemens SINAMICS S120 Commissioning Manual

2.5.2

Curve diagram

The curve diagram displays the selected signals of a recording. Binary signals are shown in
the lower diagram as bit track. You can adapt the display of the signals in the signal table
and with the toolbar of the curve diagram.
Setting options and displays in the curve diagram
The following figure shows the display in Startdrive as example:
Figure 2-12 Overview of the curve diagram
2.5.3

Signal table

The signal table lists the signals of the selected measurement and provides setting options
for some properties. If recording data of installed traces is displayed and the settings are
changed in the signal table, these settings are retained until there is a change to the offline
mode. If the installed trace is added to the measurements, the current settings of the signal
table are saved in the measurement.
The signals can be sorted using drag-and-drop. The bits of a signal can be resorted within a
signal.
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Startdrive commissioning tool
2.5 User interface - trace function
47