Display Layout; Figure 1-1 Dual Numeric Display - Keysight N432A Service Manual

1 N432A at a Glance

Display Layout

The following figure shows the display when two windows are configured in the
dual numeric mode.
Other display formats are available by pressing
1
2
3
Figure 1-1
1 The status reporting line displays messages and the control status of the
2 The measured channel is shown with a thermistor sensor connected.
3 This field displays the current bridge resistance value as an indicator with or
4 The information in this field is displayed in two lines and depends on the
5 This field displays the menu title.
24
Dual numeric display
N432A.
For example, the status can be either RMT (remote, GPIB, USB, or LAN
operation) or LCL (local, front panel operation). The message field will indicate
ERR for any error conditions that occur.
without the thermistor sensor connected.
sensor calibration factor, sensor calibration and frequency-dependent offset
tables currently selected, and the measurement frequency.
For example, Channel Setup, or press
4
and the Zero/Cal menu is displayed.
> Disp Type .
5
6
7
8
9
Keysight N432A Service Guide