AND HV-CWP Series Instruction Manual page 54

The maximum number of text data is 400 characters.
To use the UFC function, it is necessary that the PF command be used and the UFC format be
stored as text data in the scale in advance.
When the PRINT key is pressed or auto-print mode is used, the scale prints the stored text data after
variable parameters is replaced with weighing value, tare value and the like.
Specify
Store Text Data to the Scale
Command P F
,
Reply P F C
The text data (the UFC format) can sent using the PF command:
Variable parameters for the scale data and control codes
Parameter
$ID ID number
$PC Counting number
$WT Current weighing value
$TR Current tare value
$PT Current preset tare value
$TL Accumulation value
Note
These parameters must use capital letters.
ASCII text string
Text string is described in single quote marks ' .
The single quote itself is written as two single quotes.
Example of text Data :
Example of text 'Data' :
The ASCII hexadecimal code
The ASCII hexadecimal codes are written in the form # and two hexadecimal digits.
This will mainly be used to send control codes that cannot be described as a text string.
Example of EOT of ASCII code :
Data repeated
When the control codes $SP, $CR and $LF can be used with "
maximum)", these codes will be repeated the number of times designated.
to use the UFC format in the function table.
, $ P C
& $ C R ,
L
F
R
Scale Data & Control Code
, ' T E X T
$ L F , $ W T
Parameter
$AN
$CP
$CM
$CR
$LF
$SP
' '
Data
' '
''Data''
#04
52
' , # 2 0 ,
, $ C R ,
Scale Data & Control Code
Accumulation counts
Comparator result
, Comma
C Carriage Return
R
L Line Feed
F
Space
and number (of two digits in
$ S P 2
$ L F C L
F
R
Terminator
(2Ch)
(0Dh)
(0Ah)
(20h)