Congratulations on purchasing a state-of-the-art A&D health scale, one of the most advanced health scales available today. Designed for ease of use and accuracy, this device will facilitate your daily weight management regimen. We recommend that you read through this manual carefully before using the...
Failure to do so may result in a fall, causing injury. When installing the batteries, be sure that the + (positive) and - (negative) terminals are correct. Installing incorrectly may cause overheating, battery fluid leaks or rupturing of the batteries, resulting in damage to the scale or injury.
To ensure the accuracy of the measurement, when the scale is moved or not-in-use for a long time, please place the scale on a flat surface and turn it on at first. Then proceed to measurement after the scale shuts off automatically.
Page 5
Measure in Stone / Foot Start Measuring Place the scale flatly on a hard surface. Step onto the platform and stand still until the numeral on the LCD stops blinking. The measuring result is displayed for about 10 seconds. ...
Step off the platform for a platform keeps fluctuating while. Then step onto the for 12 to 18 seconds. The platform and stand still until scale will then shut off the numeral on the LCD automatically. stops blinking. Low Battery. The scale will Replace the battery.
DO use a dry soft cloth to wipe the dust. DO use a wet soft cloth, dipped into water or neutral detergent and wrung out, to wipe the dirt. Then use a dry soft cloth to dry up the device.
1 years under normal use. This Limited Warranty is personal to You and is not transferable. If a Product is defective, You can return the Product to the retailer You purchased it from (if within such retailer’s return time frame) or return it to A&D in accordance with the procedure set forth below.
Page 9
Warranty (Con’t.) This Limited Warranty does not cover, and A&D will not be liable for (i) any shipment damage, (ii) any damage or defect due to misuse, abuse, failure to use reasonable care, failure to follow written instructions enclosed with the Product, accident, subjecting the Product to any voltage other than the specified voltage, improper environmental conditions, or modification, alteration or repair by anyone other than A&D or persons authorized by A&D, or (iii) expendable or consumable components.
Need help?
Do you have a question about the UC-252 and is the answer not in the manual?
Questions and answers