Replacing Storage Enclosure Basic Psus; Removing A Storage Enclosure Basic Psus - Western Digital ActiveScale X100 Support Manual

ActiveScale™ X100 Support Guide
1. From the rear of the chassis, line the up the bottom of the fan with the rubber bumpers on the chassis.
2. Tilt the top of the fan until the fan pins line up with the connectors on the chassis.
Warning: To prevent damage to the rear fan components, press the at the top of
the fan. Do not push on the fan spokes or place the fan with the pins and
connector facing down during installation.
3. Press firmly until the fan is securely locked into place.
4. Verify that the fan LED has no faults.

3.6.4 Replacing Storage Enclosure Basic PSUs

Caution: Disconnect all power sources before servicing.
Table 3-34. Storage Enclosure Basic PSU replacement overview
Required tools
None

3.6.4.1 Removing a Storage Enclosure Basic PSUs

To remove a Storage Enclosure Basic PSU:
1. Lift the cord retention bale.
2. Unplug the power cord from the PSU.
Figure 3-69. Removing the power cables (power cables shown in red)
Personnel Replacement time
1 8 min
87