Working with the Access Point Hinged Cover
Figure 3-9
Screw a M8 x16 bolt (with flat and lock washers) into the second bolt hole on each side of the access
Step 13
point (see
Ensure that the front of the access point is vertical, and tighten the four bolts to 13 to 15 ft lbs
Step 14
(17.6 to 20.3 Nm).
When using the Cisco Aironet Dual-Band Omnidirectional Antennas, connect them to the access point
Step 15
as shown in
Continue with the
Step 16
the Access Point" section on page
Working with the Access Point Hinged Cover
This section details opening and closing the protective cover.
Opening the Access Point Hinged Cover
The hinged cover must not be opened unless the area is considered non-hazardous and the AP has been
Caution
powered off.
You need to open the access point hinged cover to access the AC entry terminal block or 24 VDC
terminal block, and when you are installing fiber-optic SFP module and fiber cable take-up reels.
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
3-58
Access Point Hanging in Mounting Bracket
Figure
3-9).
Figure
3-9. Hand-tighten the antennas to the access point.
"Grounding the Access Point (all models)" section on page 3-60
3-71.
Chapter 3
Installing the 1552 Series Access Points in Hazardous Locations
and the
"Powering