Table of Contents
Advertisement
Chapter 3
Installing the 1552 Series Access Points in Hazardous Locations
Loosen the round end of the liquid-tight connector by turning counterclockwise, but do not remove (see
Step 6
Figure
Figure 3-13
1
Step 7
Carefully screw the threaded end of the adapter into the access point and hand-tighten.
Step 8
Use an adjustable wrench, the 22 mm socket, or the Sealcon S-2200-WR wrench to tighten the threaded
end of the adapter to 6 to 7 ft lbs (8.1 to 9.5 Nm).
Step 9
Carefully remove approximately 1 to 2 ft (30.5 cm) of the external jacket from the fiber-optic cable,
exposing the inner strand.
Carefully insert the fiber-optic LC cable connector into the rounded end of the liquid-tight adapter (see
Step 10
Figure
Wrap excess fiber-optic cable around the take-up reels in a figure eight (8) pattern.
Step 11
Insert the fiber-optic LC cable connector into the SFP module.
Step 12
Step 13
Use an adjustable or open-end wrench to tighten the round end of the adapter to 2.7 to 3.2 ft lbs
(3.66 to 4.34 Nm).
Close the hinged cover (see the
Step 14
Installation Details for the 1552SA and 1552SD Access Point
There are differences in the port adapter sizes and threading between the different models. Be sure to
Note
review the connector details for the access point model you are installing in
The fiber-optic kit (AIR-1550S-FIB-KIT=) enables the 1552SA and 1552SD access points to support
fiber-optic network connections. The kit contains these parts:
•
•
3-13).
Liquid -Tight Adapter
Thread end
3-13), and push through the adapter.
Two take-up reels
One bracket to support the reels
Installation Details for the 1552SA and 1552SD Access Point
2
Round end
"Closing the Access Point Hinged Cover" section on page
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
3-59).
Connectors, page
1-7.
3-63
Advertisement
Table of Contents
