Before You Begin; Unpacking The Access Point; Package Contents; Tools And Hardware - Cisco 1552S Installation Manual

Unpacking the Access Point

Unpacking the Access Point

When you are unpacking the access point, do not remove the foam blocks attached to the antenna
connectors. The foam protects the antenna connectors during installation.
To unpack the access point, follow these steps:
Open the shipping container and carefully remove the contents.
Step 1
Return all packing materials to the shipping container, and save it.
Step 2
Step 3 Ensure that all items listed in
any item is damaged or missing, notify your sales representative.

Package Contents

The typical access point package contains the following items:
•
•
•
•
•

Tools and Hardware

The tools and hardware used to install the 1552 access point are described in:
•
•
•

Optional Tools and Hardware

The optional tools and hardware that can be obtained from Cisco are:
•
Caution: Power injector (AIR-PWRINJ1500-2=) is not certified for installation within hazardous
Caution
locations environments.
•
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
2-30
"Package Contents" section on page 2-30
Access point
Cisco product documentation and translated safety warnings
Two-pin DC power connector
Ground lug (Panduit PLCD6-10A-L) and screws with lock washers
Watertight cable glands for Power-over-Ethernet (PoE) ports (depending on the 1552 access point
model, 2 or 3 cable glands are provided)
These cable glands are NOT hazardous locations/Ex certified.
Note
Optional Tools and Hardware, page 2-30
Optional Tools and Hardware That You Supply, page 2-31
Pole Installation Hardware and Tools, page 2-31
Optional power injector (AIR-PWRINJ1500-2=)
Antennas, 2.4/5 GHz (refer to the "Antenna Configurations" section on page
Chapter 2

Before You Begin

are included in the shipment. If
1-15)