Cisco 1552S Installation Manual page 63

Chapter 3 Installing the 1552 Series Access Points in Hazardous Locations
Figure 3-1
1 Access point quick mount notch
2
Mounting holes
Use four customer-supplied screws and optional screw anchors to attach the mounting plate to the
Step 2
mounting surface.
Note
Screw a M8 x16 bolt in the top support bolt hole on each side the access point (see
Step 3
screw the bolt all the way in; leave approximately a 0.25 inch (0.635 cm) space.
Mounting Bracket for Wall Mounting
If necessary, use suitable screw anchors and an exterior-grade plywood backboard to mount the
access point to stucco, cement, or drywall.
2
3
2
1
3 Mounting slots (allows bracket rotation)
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Mounting on a Wall or a Pole
1
Figure 3-2). Do not
3-49