Table of Contents
Advertisement
Chapter 3
Installing the 1552 Series Access Points in Hazardous Locations
Powering the Access Point
Explosion Hazard—The area must be known to be nonhazardous before installing, servicing, or
Warning
replacing the unit. Statement 1082
Please refer to the Declarations of Conformity and Regulatory Information when the
Note
AIR-CAP1552H-Q-K9 (POE input configuration only) will be installed in an explosive area in Japan.
The access point can be powered by one of these methods:
1552H and 1552SA
100 to 240 VAC, 50-60Hz.
1552H
Power-over-Ethernet (PoE)—56 VDC power injector (AIR-PWRINJ1500-2=)
1552SD and 1552WU
24 VDC
In all cases above, the AC branch circuit powering the access point must be limited to no more than 20A
Note
from the over-protection device supplied by the user. This branch power protection must meet all local
and national electrical codes.
The 1552 access point for hazardous locations can be connected to more than one power source. The
access point detects the available power sources and switches to the preferred power source using the
following priority:
1.
2.
3.
Connecting a 1552H Series Power Injector
The power injector provides 56 VDC to the access point over the Ethernet cable and supports a total
end-to-end Ethernet cable length of 100 m (328 ft) from the switch to the access point.
The power injector is not intended to be installed in a hazardous locations environment. If a PoE injector
Note
is required, it must be located in a non-hazardous location environment.
The 1552SA/SD and 1552WU do not support PoE In.
Note
AC power
DC power
Power over Ethernet
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Powering the Access Point
3-71
Advertisement
Table of Contents
